As hospitals and clinics look to extend the life of their existing X-ray machines, many are asking: Can Fatali-Med X-ray tubes be installed on our current systems?
The answer is: YES.
At Fatali-Med, our X-ray tubes are engineered with cross-compatibility in mind. Whether you are upgrading, replacing, or standardizing across multiple X-ray units, our tubes can be matched by model specifications to ensure a seamless integration with your machine — be it from other widely-used systems.
Proper installation and calibration are key to optimal imaging. Here’s a simplified workflow commonly followed by radiology engineers:
Power Down the X-ray Machine – Always start with full shutdown and disconnect power.
Remove the Old Tube – Unscrew mounting brackets and gently detach connectors and cable assemblies.
Install Fatali-Med X-ray Tube – Align mounting holes and connect HV cables, filament wires, and stator connectors.
Tighten Fixtures Securely – Ensure firm installation to prevent vibrations during exposure.
Reconnect Power & Safety Checks – Run a physical inspection and safety interlock test.
Align Focal Spot – Use alignment lasers or digital templates to ensure the focal spot is centered to the detector or film plane.
Set Exposure Parameters – Input the correct voltage (kVp), current (mA), and exposure time values.
Test Image Quality – Use a test phantom or calibration pattern to check for image sharpness, noise, and artifacts.
Fine-tuning – Adjust HV waveform or exposure timing if necessary for your system.
Our customer service team provides technical documentation and remote support to guide your technicians through the process.
🔄 Cross-Compatibility with major OEMs
⚙️ Precision Focus & High Heat Capacity
🧩 Customizable Configurations (target angle, anode type, focal spot size)
🛠️ Easy Installation, Support Included
Looking to replace or upgrade your X-ray tube?
Contact us for model matching or a free technical consultation.
